Poultry Talk Ontario (pto.ca)

This is a breeding pen I built, will hold six pairs. So far I have been liking it and I think I'm going to build more, the only downside is the birds up top will kick their shavings and it lands in the waterers of the birds underneath lol. Maybe I should rig up a little roof over them or something. Most of it was left over lumber from our addition so it didn't cost a whole lot to build and I made sure it's portable for when I move out

Very nice!

That's a fantastic system.

Good job Nick, how much of this project did your Devrann help you with? Did she do most of the work, or was she the supervisor?

Well she was there supervising for sure haha, she helped me eye ball the pearches up. Made sure they were level And helped me paint it. I like it I want to build some more forsure

Great job. That's what I need :smile:

Thanks, one day I plan to have a wall full of these :) if I'm lucky that is

Very nice . Can you put a strip of 1/4 along cages at bottom on outside to stop shavings ? Or 4" high plexi glass ? Looks nice & warm .

I could try that Ross, it's not a huge deal I have one pair on wyndottes that are the worst maybe I'll just put them on the bottom lol. I have a real problem with those little waterers freezing so I hung those red light there and they never freeze. Just gotta make sure I throw my dad some money each month for hydro!!

Yep they work good . Have used similar in front of my pigeon battery nest boxes when i used to show & had to raise birds early in cold for fall shows . Luck